Recent content by Antcy18

Credit

Yes, but they will create you that amount

Wipers yes, but I used a single manual wiper on the drivers side. The windshield from df goblin passed inspection. I don’t have fenders or bumpers and that’s fine in Ohio but the inspector thought I needed a rear bumper, I showed her a section of Ohio code that states otherwise and she was great...

I am from Canfield, Ohio and am now officially registered, titled and insured in Ohio 2007 Manual LS Donor

I just got mine registered Today here in Ohio, insured, and on the road today!

I use hook up the steering wheel control wire and the hazard wire to the hazard switch? I'm lost on what to do with the steering wheel control wire near the button panel?

I figured it out, I did not have a wire running from my starter to my positive post. Thanks everyone, first start felt GREAT! Now my starter is shot, but it still had one good one left in it!

I have no power to my post on the engine fuse box? The red and gray thick wire is showing 12volts coming out of the red connector in the dash fuse box, but there is no power to it when it enters the engine fuse box. Thoughts?

I'm trying to get the dash lights on and the throttle butterfly to respond, but when I turn the key I'm getting nothing. I have 1.4 volts to the red/white power wire on the green ignition connector. For some reason it's not grounded so I bypassed it with the separate ground wire just to test...

Thanks Lonny!

I have 4 connectors that I want to make sure I'm right on. 07 LS, Manual Trans....Please advise: Connector 1: I think is the Amplifier Connect and needs cut out. Connector 2: No sure, maybe radio or speaker? Connector 3: I think is the steering wheel controller, but it doesn't have a...

I'm stuck on the same part with the Shift Select Switch, I wanted to know if you ended up figuring it out?

So Lonny, I should leave any of those wires in question then like D3 pins and D4 pins?

Update, I have a Red and white wire in D3 on the dash and body connector. Is this the OBD2 power? I've attached pictures, there are two red/white wires paired together in the dash connector D3 pin.

I in the process of working through wiring video 4 and labeling the wires from the body to dash harness. My donor is a 07 LS, manual. In the B5 pin location I have a yellow wire but it calls for a Dark Blue/White. Is this okay? Do I assume that it is the right wire just different color? In my...