Recent content by jtelling325

I pray to sweet baby jesus it goes that smooth for me.

I picked up a washer kit off Amazon for $11. I'll install it for the inspections and then get rid of it. The cop said the state inspector will look for the AS1 engraving, so thats why he failed it. I reached out to mjgrusni and he(?) is going to send me his design.

Unfortunately a windshield is a requirement in Michigan.

I was never notified for your reply! :confused: I appreciate it but I don't think them. I just had the initial police inspection done and the officer said it didn't need them because it sat so low. However, he did fail me because the windshield is plexiglass and I don't have real squirters for...

I know this is a long shot, but does anyone have some bumpers i could borrow for my inspection? or maybe some plans so i could have some made?

Where about in Mid-Michigan? I'm ready to get mine road legal and I'm looking for the easiest department to work with. I'm in Lansing.

I thought about doing that, but my OCD won't allow it :p

So I think I threw out some stock hoses for the radiator. How do I complete the radiator hoses on the driver and passenger side? Also, does anyone have a part number or an STL file for the bracket that holds the supercharger coolant sight glass?

I was hoping they were going right down the road, but they told me they had about an hour drive! Good luck and Godspeed!

When you want that scrap so bad but didn't bring a trailer lol

Where did you get this? I really like this style.

I rewatched the previous video twice and didn’t miss anything. Out of the four grounds that were extended, one was pulled towards the bcm (not used since it’s SC), two to the tail lights, and the last to the license plate light. I bundled the abs lug, fuel pump, and coolant tank grounds. I...

In step 6, it says to solder the ground lug, fuel pump ground, coolant tank ground, and fuse box ground together. Where does the fuse box ground come from?