Late model booster spacer if you need

[comegetjoe]

Got what I needed. Thank you.

I have a late model booster spacer if someone needs.

 

[comegetjoe]

I have a spacer for a late model booster if someone needs.

 

[RGSkid70]

-3- I also was missing the little foam/fabric spacer on the brake booster rod. I replaced it with a short piece of PVC pipe, held in place with a circlip.

 

[Desert Sasqwatch]

I hope this doesn't cause any pedal bind. The foam piece is just stiff enough to keep the pedal arm in place, but allows for some lateral travel on the pin. Please, for safety, make certain to check the pedal for travel after everything is mounted up - would hate to have a brake issue at an inopportune time.

 

[RGSkid70]

There's still plenty of play in the shaft to prevent binding. The pvc piece is approximately the same thickness as the fuzzy bushing.

 

[SwerveMonkey]

Heya @comegetjoe you still have that spacer available??

 

[comegetjoe]

Heya @comegetjoe you still have that spacer available??

I can't find the one I have listed, but I think I can spare the one off the listed parts car.

 

[SwerveMonkey]

any chance you could give me a cost estimate including shipping??
weighing in cost/time for delivery versus scrounging in local junkyard and cost there.

although, getting dimensions on this thing would also be a nice thing maybe I could get some machined

 

[comegetjoe]

If you're legit on getting dimensions and replicating it, I'll get it out to you.

 

[Desert Sasqwatch]

Or use some thick washers if the spacer cannot be obtained - will accomplish the same outcome. Someone who has a spacer could measure it to get the proper depth.

 

[comegetjoe]

Or use some thick washers if the spacer cannot be obtained - will accomplish the same outcome. Someone who has a spacer could measure it to get the proper depth.

I'm standing right here ya know

 

[SwerveMonkey]

Or use some thick washers if the spacer cannot be obtained - will accomplish the same outcome. Someone who has a spacer could measure it to get the proper depth.

I do have a couple washers that are about 10mm thick,,, wasnt sure that it would do the job correctly and be able to stabilize the thing too.

 

[Desert Sasqwatch]

The spacer is thicker than 10mm if I remember correctly.

And sorry @comegetjoe - didn't mean to sidetrack your deal to off load the spacer to @SwerveMonkey. My bad!

 

[comegetjoe]

I'm not offloading it. I'd ship it to help the community. I don't want money for it.

 

[Desert Sasqwatch]

Pay it forward...it's the right thing to do with donor parts we won't be using. Been there and doing that every chance I get to help a fellow builder in need!