• We've upgraded and reskinned the forum. Notice something off? Email us at [email protected] and we'll fix it.

V1 Fenix's Goblin #461 - 2010 Base Auto

Ross
Well X1 15 does go thru the coil in the run/crank relay, then to ground. So there is a direct path to ground.
Remove that relay, and it shouldn't go to ground.
 
Fenix Nexen
Unwrapping the harness, confirm that 5 green wires are connected
 

Attachments

  • 16858397888122031152653852552727.jpg
    16858397888122031152653852552727.jpg
    156.5 KB · Views: 313
Ross
Fenix Nexen said:
sorry forgot to mention both ends are unplugged during this test
Click to expand...
Both ends of the wire are unplugged, and you are getting continuity to ground?
That is a big issue.
If you disconnected the wires at the red lines (unplugged them) then that wire should not be connected to ground.

40824
 
Last edited:
Fenix Nexen
Going to take out the harness completely, throw it on the healing bench, unwrap it and look over bar-air's notes... Will be using something besides electrical tape next time I wrap it
 
Robinjo
On the photos of green wires, is #4 Theft Deterrent supposed to be connected to the bundle of green wires that get soldered together? I don’t think it was.
 
A
Fenix Nexen said:
Going to take out the harness completely, throw it on the healing bench, unwrap it and look over bar-air's notes... Will be using something besides electrical tape next time I wrap it
Click to expand...
WOW! GOOD JOB! (first response now useful but not timely:)) "The Healing Bench"! Bravo for that attitude! It's hard to be calm when facing that bundle of wiring that looks like an octopus orgy gone wrong! But It Does All Make Sense, ya just got to break it down into circuits. Patience is key. Cheers and Best of Luck! You will whip this thing!
 
Last edited:
You must log in or register to reply here.
Back
Top