V1 SS/SC 2006 open cage easy entry standard length

[Ross]

You up to the challenge?
GM F35 Transmission Disassembly

 

[JBINTX]

Not too bad if you have the tools and have done it before. I think we charge $500 to do it.

"Not too bad if you have the tools and have done it before"

Do not take that lightly from Lonny. He makes a LOT look easy.......

 

[r3drckt]

"Not too bad if you have the tools and have done it before"

Do not take that lightly from Lonny. He makes a LOT look easy.......

So much truth to this statement!

 

[r3drckt]

You up to the challenge?
GM F35 Transmission Disassembly

I’m always up to the challenge. If i wasn’t, I wouldn’t be building a kit car

 

[Aguinaga]

First huge shout out to Kimberly Coker for taking care of my UPS issues.

So, what is people’s favorite brand/hub for the front….. smh.

 

[Vwsaabvt]

First huge shout out to Kimberly Coker for taking care of my UPS issues.

So, what is people’s favorite brand/hub for the front….. smh.

timkin, skf, moog

 

[95Blitz]

First huge shout out to Kimberly Coker for taking care of my UPS issues.

So, what is people’s favorite brand/hub for the front….. smh.

DF 5 lug redrilled.

 

[Aguinaga]

What am I missing please and thank you.

 

[jayrolls]

What am I missing please and thank you.

Your not kissing anything. There are just two spots on the switch.

 

[Jareth]

Your not kissing anything. There are just two spots on the switch.

I would have to agree, don't kiss anything until you clean the dirt off of it

 

[Rttoys]

What am I missing please and thank you.

Nothing. It stays empty. I thought the same thing with mine.

 

[jayrolls]

Nothing. It stays empty. I thought the same thing with mine.

Not Missing*

 

[Aguinaga]

Thank you guys

 

[Aguinaga]

When the F35 gets all put back together. They do not make it easy to rebuild these.

 

[Scott #321]

Where were you able to source parts. The searching I did was resulting in close to $500 for the crush sleeve, main nut, gasket set and 2nd gear synchronizer. Being that mine does not have quafie I was planning on going f23 due to cost and parts availability.

 

[Aguinaga]

Honestly my uncle rebuild it for me. He has been working on transmissions for 30 years. The bearings were the pain because they are pressed into case so not on your typical rebuild blueprints. A local bearing shop measured them and went looking.

 

[jayrolls]

When the F35 gets all put back together. They do not make it easy to rebuild these.

You won’t need the clutch line connected to the clutch elbow.

 

[Aguinaga]

You won’t need the clutch line connected to the clutch elbow.

Extra parts pile. Thank you

 

[Rauq]

You will need the retaining clip off of the elbow though, don't lose that!

 

[jayrolls]

You will need the retaining clip off of the elbow though, don't lose that!

Great call.